Steam Car Club : The Steam Car.....Forum
Looking for (American standard) No.6 NC countersunk head screws , 1/2" long.
They are 32 tpi, and I need a couple of dozen at most to replace missing ones from the windscreen of my Stanley 607. They were used to fit the Murphy fasteners. NIckel plated brass would be best, but brass or staniless is a good substitute.
See table at [www.sizes.com]
Anyone know of a supplier?
The Official Forum for the Steam Car Club
Supplier - No.6 NC countersunk head screws
Posted by: (---.proxy.aol.com)
Date: June 23, 2010 04:05PM
Looking for (American standard) No.6 NC countersunk head screws , 1/2" long.
They are 32 tpi, and I need a couple of dozen at most to replace missing ones from the windscreen of my Stanley 607. They were used to fit the Murphy fasteners. NIckel plated brass would be best, but brass or staniless is a good substitute.
See table at [www.sizes.com]
Anyone know of a supplier?
Re: Supplier - No.6 NC countersunk head screws
Posted by: Rolly (---.hsd1.ma.comcast.net)
Date: June 23, 2010 05:45PM
Re: Supplier - No.6 NC countersunk head screws
Posted by: Mark Drake (62.189.28.---)
Date: June 24, 2010 05:18AM
Hi Peter,
I've been getting most of my screws from Ryders of Bury, they've been very helpful:
[www.screwsline.co.uk]
Worth a try.
Regards,
Mark
I've been getting most of my screws from Ryders of Bury, they've been very helpful:
[www.screwsline.co.uk]
Worth a try.
Regards,
Mark
Sorry, only registered users may post in this forum.