Steam Car Club Forum
Steam Car Club : The Steam Car.....Forum
The Official Forum for the Steam Car Club
The fastest message board....ever.
Goto Thread: PreviousNext
Goto: Forum ListMessage ListNew TopicSearchLog In
Goto Page:  Previous12
Current Page:2 of 2
Re: Stanley Engine Questions
Posted by: (---.wavecable.com)
Date: December 19, 2012 09:23PM

A hone that has spring loaded hone stones will never hone a round bore out of a less than round bore. It is good for breacking a glaze on the cylinder walls. A micrometer dialed hone like the one that I use, makes a percectly round cylinder without taper. If the wear is all on the bottom of the Stanley bore like described, true, a rebore with a boring bar is the only choice availalbe to return the cylinder to perfectly on center again.

Goto Page:  Previous12
Current Page:2 of 2


Sorry, only registered users may post in this forum.
The Steam Car Club Forum
NPC - Sitemap