Steam Car Club Forum
Steam Car Club : The Steam Car.....Forum
The Official Forum for the Steam Car Club
The fastest message board....ever.
Goto Thread: PreviousNext
Goto: Forum ListMessage ListNew TopicSearchLog In
Stanley tube flaring
Posted by: (---.as43234.net)
Date: February 10, 2014 09:53AM

I have bought simple Draper 45 degree pipe flaring tool to
do the flares for the new pilot tank and steam enema on our car.

However, after making a few trial flares on bits of scrap tube noticed that the
angle of flare seems slightly different to that on old and new the fittings I have.

I guess that as its all copper pipe small differences will pull up tight, but wanted to ask if others have come across this before going much further in case I needed to get a 37 degree or other angle flare tool instead!

Re: Stanley tube flaring
Posted by: (---.wavecable.com)
Date: February 10, 2014 12:12PM

Use you modern flaring tools. As you tighten up on your tubing nuts, the angles will correct themselves for a good fit.

Re: Stanley tube flaring
Posted by: Donald Cook (---.range86-183.btcentralplus.com)
Date: February 10, 2014 04:28PM

Peter,

I turned a new end to the correct angle to fit my flaring tool. Also donít forget to anneal the tubing before and after flaring.

Don

Re: Stanley tube flaring
Posted by: (---.as43234.net)
Date: February 23, 2014 05:08AM

Thanks for your advice everyone; I made a 60 degree Stanley flare angle adapter to fit the Draper flaring tool - see [flic.kr] - and after a bit of practice managed to produce clean & straight flares.



Sorry, only registered users may post in this forum.
The Steam Car Club Forum
NPC - Sitemap